Hide Table of Contents

Print Properties - Paper Size and Orientation

Use the Paper Size and Orientation page of the Print Properties dialog box to select the paper size and orientation or let the user make these selections.

To display this page:

Expand the Tasks node and click Print. In the left pane, click Paper Size and Orientation.

Use paper size and orientation stored in drawing if available If paper size and orientation are stored with the drawing, uses them. Otherwise, uses selected paper size and orientation.

Paper Size

Default size
Series Millimeters Inches
A   8 ½ x 11
B   11 x 17
C   17 x 22
D   22 x 34
E   34 x 44
A0 841 × 1189 33.1 × 46.8
A1 594 × 841 23.4 × 33.1
A2 420 × 594 16.5 × 23.4
A3 297 × 420 11.7 × 16.5
A4 210 × 297 8.3 × 11.7
Allow the user to change the size  

Default orientation

Allow the user to change the orientation  

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Print Properties - Paper Size and Orientation
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS PDM 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.