Hide Table of Contents

Frequency Analysis (Available in SolidWorks Simulation)

A body disturbed from its rest position tends to vibrate at certain frequencies called natural, or resonant frequencies. For each natural frequency, the body takes a certain shape called mode shape. Frequency analysis calculates the natural frequencies and the associated mode shapes.

In theory, a body has an infinite number of modes. In FEA, there are theoretically as many modes as degrees of freedom (DOFs). In most cases, only a few modes are considered.

Resonance is the excessive response that occurs when a body is subjected to a dynamic load vibrating at one of its natural frequencies. For example, a car with an out-of-balance tire shakes violently at a certain speed due to resonance. The shaking decreases or disappears at other speeds. Another example is that a strong sound, like the voice of an opera singer, can cause a glass to break.

Frequency analysis can help you avoid resonance by calculating the resonant frequencies. It also provides information to solve dynamic response problems.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Frequency Analysis (Available in SolidWorks Simulation)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.