Hide Table of Contents

Running Motion Studies for Layout Sketch Mechanisms

To run a motion study for a layout sketch:

  1. Create the layout sketch mechanism, editing Mass Properties in the Block PropertyManagers as necessary.

    Mass properties are used only for motion calculations in Motion Analysis studies.

  2. Create a motion study for the layout sketch.

    Constraints you apply in the layout sketch appear as mates in the motion study. You cannot edit these mates.

  3. Add motion study elements, such as forces or motors, as necessary.

    You cannot add contact between layout sketch blocks.

  4. Select either Motion Analysis or Animation and run the motion study.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Running Motion Studies for Layout Sketch Mechanisms
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23