Hide Table of Contents

Heal Edges PropertyManager

To heal edges:

  1. Click Heal Edges Tool_Heal_Edges_Features.gif (Features toolbar) or Insert > Face > Heal Edges.
  2. In the PropertyManager, under Faces:
    • Select the faces whose edges you want to heal for Face(s) to Heal PM_face.gif.
    • Set Angular Tolerance to the maximum angle between the edges to be merged.
    • Set Edge Length Tolerance to the maximum length of edges to be merged.

      Example: If you set Angular Tolerance to 2deg and Edge Length Tolerance to 5mm, then edges with angles less than 2° at the vertex between the edges, and length less than 5 millimeters, merge into one edge.

  3. Click Heal Edges.

    Under Edge Information, Before and After display the number of edges in the part before and after the Heal Edges operation.

  4. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Heal Edges PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.