Hide Table of Contents

Radiate Surface

The Radiate Surface tool creates a surface by radiating edges of solids or surfaces along a selected planar direction.

To created radiated surfaces:

  1. Click Radiate Surface (Surfaces toolbar) or Insert > Surface > Radiate.
  2. In the PropertyManager, under Radiate Parameters:
    1. Select a face or plane in the graphics area that is parallel to the direction in which you want the surface to radiate for Radiate Direction Reference.

      The arrow in the graphics area points normal to the selected reference, but the surface radiates parallel to the selected reference.

    2. Select an edge or a set of contiguous edges in the graphics area for Edges To Radiate .

    3. If necessary, click Flip Radiate Direction to radiate the surface in the opposite direction.
    4. Select Propagate to tangent faces if the model has tangent faces and you want the radiated surface to continue along those faces.
    5. Set Radiate Distance to determine the width of the radiated surface.
  3. Click OK .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Radiate Surface
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.