Hide Table of Contents

Sketch Chamfer PropertyManager

To open the Sketch Chamfer PropertyManager:

In an open sketch, click Sketch Chamfer Tool_Sketch_Chamfer_Sketch.gif on the Sketch toolbar, or click Tools > Sketch Tools > Chamfer.

Chamfer Parameters

Angle-distance

Distance 1 PM_distance1.gif

Applied to the first sketch entity selected.

Direction 1 Angle PM_angle.gif

Applied from the first sketch entity toward the second.

Distance-distance
  • Equal distance selected. Distance 1 PM_distance1.gif is applied to both sketch entities.
  • Equal distance cleared. Distance 1 PM_distance1.gif is applied to the first sketch entity selected. Distance 2 PM_distance2.gif is applied to the second sketch entity selected.
Angle-distance Distance-distance Equal distance
chamfer_angle-distance.gif chamfer_distance-distance.gif chamfer_distance-distance_equal.gif


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Chamfer PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.