Hide Table of Contents

2D Sketching in 3D

When you open a sketch in 3D, you can start the sketch anywhere. This adds an origin. To use a 2D sketch mode in a 3D sketch, activate a planar face by adding a 3D sketch plane. You can also click 3D Sketch on Plane Tool_3D_on_a_Plane.gif (Sketch toolbar) or Insert > 3D Sketch on Plane to start sketching in a 2D mode. This provides some additional benefits:
  • Inferences. More relations are available, with some restrictions. See Sketch Relations in 3D Sketches.
  • Snapping. Only occurs with the geometry in the sketch plane. Exceptions include:
    • Snap to a curve that passes through a plane and infer coincidence between the sketched point and the curve.
    • Snap to points off the plane when viewing that plane normal to. This ensures that the point is coincident with the projection onto the plane.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   2D Sketching in 3D
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.