Hide Table of Contents

Construction Geometry

You can convert sketch entities in a sketch or drawing to construction geometry. Construction geometry is used only to assist in creating the sketch entities and geometry that are ultimately incorporated into the part. Construction geometry is ignored when the sketch is used to create a feature. Construction geometry uses the same line style as centerlines.

Any sketch entity can be specified for construction. Points and centerlines are always construction entities.

The SolidWorks software also has Reference Geometry (planes, axes, and so on) as a basis for creating features outside of sketches.

Converting Sketch Entities to Construction Geometry

To convert sketch entities to construction geometry:

  • In an open sketch, select one or more sketch entities and do one of the following:
    • Select For construction in the PropertyManager.
    • Click Construction Geometry Tool_Construction_Geometry_Sketch.gif on the Sketch toolbar.
    • Click Tools > Sketch Tools > Construction Geometry.
    • Right-click a sketch entity and select Construction Geometry (drawings only).


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Construction Geometry
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.