Hide Table of Contents

Display States in Assemblies

You can define different combinations of the following settings for each component in an assembly, and save them in display states:
Hide/Show
Display Mode
Appearance
Transparency

You change display settings for each component in the Display Pane.

Display states are listed in the bottom section of the ConfigurationManager, where you can select or clear Link Display States to Configurations to control the display state mode.

You can rename display states and select options in the Display State Properties PropertyManager.

In the Open dialog box, you can select a display state while opening an assembly.

Display State-1 Display State-2

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Display States in Assemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48