Hide Table of Contents

Working with Subassemblies

When an assembly is a component of another assembly, it is referred to as a subassembly. You can nest subassemblies in multiple levels, to reflect the hierarchy of your design.

Creating a Subassembly

There are several ways to create a subassembly:

  • You can create an assembly document as a separate operation, then make it a subassembly by inserting it as a component in a higher-level assembly.
  • You can insert a new, empty subassembly at any level of the assembly hierarchy while you are editing a top-level assembly, then add components to it in a variety of ways.
  • You can form a subassembly by selecting a group of components that are already in the assembly. This creates a subassembly and adds components to it in a single step.

Modifying a Subassembly

As you develop an assembly, you can modify its subassemblies in these ways:

  • You can dissolve a subassembly into individual components, thereby moving the components up one level in the assembly hierarchy.
  • You can edit the assembly structure by moving components up or down in the hierarchy, or to a different branch of the hierarchy. There are two ways to do this:
    • Drag and drop the components to move them from one assembly to another.
    • Click Tools > Reorganize Components. This method can be easier to use when the FeatureManager design tree is very long, and therefore requires a lot of scrolling.
  • You can change the order of the components within a level of the hierarchy.

Limitations in Subassembly Editing

Most of the operations available for editing a subassembly on its own are available when editing a subassembly in context. However, there are a few operations that cannot be performed while editing a subassembly in context:

  • Creating a new component in context
  • Inserting or modifying a weld bead

For these operations, you must open and edit the subassembly in its own window.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Working with Subassemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.