Hide Table of Contents

Changing or Removing Fillets

To automatically change or remove fillets using the FilletXpert Change tab:

  1. In the FilletXpert PropertyManager, click the Change tab.
  2. Inspect the fillet to change. Hover over the fillet in the FeatureManager design tree and note that it is applied to multiple edges. In this example, you want to change the lower edge only.

  3. In the graphics area, select the lower filleted edge.

  4. Set the Radius to 1.0, then click Resize.

    The FilletXpert resizes only the selected edge by creating a new fillet for it.

  5. Hover over another fillet in the FeatureManager design tree that is applied to multiple edges. You want to remove the fillet from the circular edge only.

  6. Select the circular filleted edge.

  7. Click Remove.

    The FilletXpert removes the fillet from the circular edge only.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing or Removing Fillets
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.