Hide Table of Contents

Cosmetic Patterns

The cosmetic pattern feature allows you to cosmetically define and display patterns of holes instead of showing fully-tessellated solid models. Rebuild time is greatly reduced because pattern geometry is only cosmetic.

You can apply cosmetic patterns only to planar, parallel faces.

You can view cosmetic patterns in drawings with shaded views while RealView is on.

To create cosmetic patterns:

  1. From the Task Pane, select the Appearances, Scenes, and Decals tab.
  2. Under Appearances, click Miscellaneous > RealView Only Appearances, then double-click cosmetic hole pattern or drag it into the graphics area.

    You need to pre-select the face for other Appearances. Pre-selection does not work for cosmetic patterns.

  3. In the PropertyManager, select a face for Fill Boundary .
  4. Under Pattern Layout:
    1. Select a layout.
    2. Set the spacing options.
    3. Select an edge to determine the pattern direction.
  5. Under Seed Types:
    1. Select a seed type.
    2. Set the size options.
  6. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Cosmetic Patterns
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.