Hide Table of Contents

Extending with Power Trim

You can use Power trim to extend sketch entities along their natural paths.

Arcs have a maximum extension length on either side of the arc. Once you reach the maximum extension length, the extension shifts to the opposite side.

To extend with the Power trim option:

  1. Right-click the sketch and select Edit Sketch.
  2. Click Trim Entities Tool_Trim_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Trim.
  3. In the PropertyManager, under Options, select Power trim PM_trim_power_trim.gif.
  4. Select anywhere along the sketch entity to extend.
  5. Click and drag the pointer as far as you want to extend the sketch entity.
  6. Release the pointer when finished extending the sketch entity, then click PM_OK.gif.

    Video: Power Trim - Extend



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Extending with Power Trim
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.