Hide Table of Contents

Creating a Helix or Spiral

You can create a helix or spiral curve in a part.

  1. In a part, do one of the following:
    1. Open a sketch and sketch a circle.
    2. Select a sketch that contains a circle.

    The diameter of the circle controls the starting diameter of the helix or spiral.

  2. Click Helix and Spiral (Curves toolbar) or Insert > Curve > Helix/Spiral .
  3. Set values in the Helix/Spiral PropertyManager.
  4. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Helix or Spiral
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48