Hide Table of Contents

Limit Mates

Limit mates allow components to move within a range of values for distance and angle mates. You specify a starting distance or angle as well as a maximum and minimum value.

To add a limit mate:

  1. Click Mate (Assembly toolbar) or Insert > Mate.
  2. Under Mate Selections, select the entities to mate together for Entities to Mate .
  3. In the PropertyManager, under Advanced Mates:
    1. Click Distance or Angle .
    2. Set Distance or Angle to define the starting distance or angle.
    3. Select Flip Dimension to move the entities to opposite sides of the dimension.
    4. Set Maximum Value dim_lin_vert_max.png and Minimum Value dim_lin_vert_min.png to define the maximum and minimum extents of the limit mate.
  4. Click .

    A LimitDistance or LimitAngle mate is added to the assembly.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Limit Mates
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.