Hide Table of Contents

Making Paths

To create a path:

  1. Sketch a model to represent a cam and another model to represent a follower.

    path_cam.gif path_follower.gif
    Cam Follower

  2. Make each sketch a block, and position the cam below the follower.

    Although not required, making the sketches blocks provides more control of the sketches.

  3. Select an arc on the cam and click Make Path Tool_Make_Path_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Make Path.

    path_cam-follower_03.gif

  4. In the Path Properties PropertyManager, under Definition, click Edit Path.
  5. Add the remaining sketch entities that form the chain for Selected Entities, then click PM_OK.gif.

    path_cam-follower_02.gif

  6. Click Add Relation Tool_Add_Relation_Dimensions_Relations.gif (Dimensions/Relations toolbar) or Tools > Relations > Add :
    1. Add relations to the cam and follower to prevent motion that is extraneous to the intended motion between cam and follower.

      Relations added:

      • Horizontal
      • Vertical between midpoint (horizontal sketch entity and arc center)
      • Fix center of bottom arc

      path_cam-follower_04.gif

    2. Add a Tangent relation between the top arc of the cam and the bottom sketch entity of the follower.

      path_cam-follower_05.gif

  7. Click PM_OK.gif.

    path_cam-follower_06.gif

  8. Rotate the cam to preview the motion.

    Video: Simple Cam Follower



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Making Paths
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23