Hide Table of Contents

Mirroring Existing Sketch Entities

To mirror existing sketch entities:

  1. In an open sketch, click Mirror Entities Tool_Mirror_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Mirror.
  2. In the PropertyManager:
    1. Select sketch entities for Entities to Mirror PM_entities_to_mirror.gif.

      mirror_existing_entities_01.gif

    2. Do one of the following:

      • Clear Copy to add a mirror copy of the selected entities and remove the original sketch entities.
      • Select Copy to include both the mirrored copy and the original sketch entities.

    3. Select an edge or a line to Mirror about PM_mirror_about.gif.

      mirror_existing_entities_02.gif

  3. Click PM_OK.gif.

    mirror_existing_entities_04.gif mirror_existing_entities_03.gif
    Results with Copy cleared Results with Copy selected



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Mirroring Existing Sketch Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.