Hide Table of Contents

Sketching Partial Ellipses

You can create a partial ellipse (an elliptical arc) from a centerpoint, a start point, and an end point, similar to creating a centerpoint arc.

To create a partial ellipse:

  1. In an open sketch, click Partial Ellipse Tool_Partial_Ellipse_Sketch.gif on the Sketch toolbar, or click Tools > Sketch Entities > Partial Ellipse .

    The pointer changes to pointer_partial_ellipse.gif.

  2. Click in the graphics area to place the center of the ellipse.
  3. Drag and click to define one axis of the ellipse.
  4. Drag and click to define the second axis.

    The circumference guideline remains.

  5. Drag the pointer around the circumference to define the extent of the ellipse, then click to complete the ellipse.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketching Partial Ellipses
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.