Hide Table of Contents

Sketching Polygons

Create equilateral polygons with any number of sides between 3 and 40.

To create a polygon:

  1. Click Polygon Tool_Polygon_Sketch.gif on the Sketch toolbar, or click Tools > Sketch Entities > Polygon.

    The pointer changes to Pointer_Polygon.gif.

  2. Set the properties in the Polygon PropertyManager as necessary.
  3. Click in the graphics area to place the center of the polygon, and drag out the polygon.

    sketch_polygon.gif

    Video: Sketching a Polygon

  4. To sketch another polygon, click New Polygon and repeat steps 2 through 5.
  5. Click PM_OK.gif.

    The Polygon tool is still active. You can create additional polygons, although the PropertyManager does not open.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketching Polygons
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.