Hide Table of Contents

Switching Between SpeedPak and Parent Configurations

After an assembly is opened, you can switch subassemblies back and forth between a SpeedPak configuration and the SpeedPak's parent configuration. You can select one or more subassemblies to switch, or specify to switch all subassemblies.

A SpeedPak configuration is always a derived configuration. A subassembly might have some configurations that have associated SpeedPak configurations, and some that do not.
In the FeatureManager design tree, the icon indicates a subassembly whose active configuration is a SpeedPak configuration.

To switch between SpeedPak and parent configurations:

  1. In the FeatureManager design tree, right-click one of the following:
    • The top-level assembly (affects all subassemblies)
    • One or more selected subassemblies (affects only the selected subassemblies)
  2. Click one of the following:
    Option Description
    Use SpeedPak For subassemblies whose active configuration is the parent of a SpeedPak configuration, switches to the SpeedPak configuration.
    Set SpeedPak to Parent Switches from the SpeedPak configuration to the SpeedPak's parent configuration.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Switching Between SpeedPak and Parent Configurations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.