Hide Table of Contents

Stretching Sketch Entities

To stretch sketch entities:

  1. In Edit Sketch mode click Stretch Entities Tool_Stretch_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Stretch Entities.
  2. In the PropertyManager, under Entities to Stretch, select sketch entities for Sketch item or annotations.
  3. Under Parameters, select either From/To or X/Y:

    Parameter Instructions for modifying parameters
    From/To
    1. Click Base point Base_point_Move_Copy.gif and then click on the sketch to set a base point.
    2. Drag to stretch the sketch entities.

      When you release, the entities stretch to that point and the PropertyManager closes.

    X/Y
    1. Set values for Delta X PM_DeltaX_big.gif and Delta Y PM_DeltaY_big.gif to stretch the sketch entities.
    2. Click Repeat to stretch the entities again by the same distance.
    3. Click PM_OK.gif.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Stretching Sketch Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.