Hide Table of Contents

Swept Surface

To create a swept surface:

  1. Create planes for sketching the sweep profile, sweep path, and if necessary, the guide curves.
  2. Sketch the sweep profile and path on the planes that you created.

    You can also sketch the sweep path on a model face or use a model edge for the path.
    Profile sketch Profile sketch with path sketch
    Preview of sweep

  3. If you are using guide curves, create coincident or pierce relations between the guide curves and the profile.
  4. Click Swept Surface (Surfaces toolbar) or Insert > Surface > Sweep.
  5. Set the PropertyManager options.
  6. Click OK .

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Swept Surface
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.