Hide Table of Contents

Trimming with Trim to Closest

  1. Right-click the sketch and select Edit Sketch.
  2. Click Trim Entities Tool_Trim_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Trim.
  3. In the PropertyManager, under Options, click Trim to closest PM_trim_trim_to_closest.gif.

    The pointer changes to Pointer_Trim.gif.

  4. Select each sketch entity you want trimmed or extended to the closest intersection:
    • To extend, select the entity and drag to the intersection.
    • To trim, select the sketch entity.
  5. Click PM_OK.gif.

    Video: Trim to Closest



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Trimming with Trim to Closest
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.