Hide Table of Contents

Detecting Interferences Between Assembly Components

To check for interferences in an assembly:

  1. Click Interference Detection (Assembly toolbar) or Tools > Interference Detection .
  2. In the PropertyManager:
    1. Make selections and set options.
    2. Under Selected Components, click Calculate.

    The detected interferences are listed under Results. The volume of each interference appears to the right of each listing. Under Results, you can:

    • Select an interference to highlight it in red in the graphics area.
    • Expand interferences to display the names of the interfering components.
    • Right-click an interference and select Zoom to selection, to zoom to the interfering components in the graphics area.
    • Right-click an interference and select Ignore.
    • Right-click an ignored interference and select Un-Ignore.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Detecting Interferences Between Assembly Components
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.