Hide Table of Contents

Example: Using Feature Selector

When you select the right-hand face of the model (blue), you can use that face to define a plane feature, or combine it with another planar face to define a width as the origin feature, depending on the design intent.

  1. Click Location Dimension and select the face shown as the origin feature.

  2. Select the inner-left face of the notch as the tolerance feature.

    Location dimension with Notch selected in the feature selector as the tolerance feature type Location dimension with Plane selected in the feature selector as the tolerance feature type.

  3. Click to place the location dimension and open the DimXpert PropertyManager. Video: Using Feature Selector


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example: Using Feature Selector
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23