Hide Table of Contents

Redrawing OLE Items in Drawings

If any part of an active OLE item in a drawing is covered, the item may not redraw when it is uncovered. This behavior may occur, for example, when you move a stencil across an active Visio item.

To redraw the OLE item and restore the drawing, do one of the following:

  • Deactivate the OLE item and reactivate it.
  • Select one of the eight handles on the border of the OLE items.
You can move OLE items in front of or behind drawing views and annotations. Right-click the OLE item and select Bring To Front or Send To Back.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Redrawing OLE Items in Drawings
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.