Hide Table of Contents

Repairing the Installation

If an error or cancellation occurs during installation, you can use Windows Control Panel to repair the installation.

You can repair an individual installation. You cannot repair an administrative image installation; you must uninstall and then reinstall the administrative image.

To repair the installation:

  1. In Windows 7 or later, click Start > Control Panel > Programs and Features. For earlier versions of Windows, click Start > Control Panel > Add or Remove Programs .
  2. Select the version of SolidWorks that failed and click Change.

    SolidWorks Installation Manager starts.

  3. In the Welcome screen, click Repair the individual installation (on this computer). and click Next.
  4. Select the products that failed to install or remove and click Repair.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Repairing the Installation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.