Hide Table of Contents

Select Partial Loop

Imported models can contain many small edges. To repair or edit imported models, you often need to select a series of connecting edges.

When surfaces or solids contain small edges, use Select Partial Loop to choose a chain of connecting edges. The chain direction is based on the relative position of the second open edge that you select:

  • Left of midpoint. Chain moves left.
  • Right of midpoint. Chain moves right.

The chain always includes the first edge you first selected.

To use Select Partial Loop with solid bodies, the selected edges must be on the same face
Loop direction, with edge 1 and edge 2

To select a partial loop:

  1. Select the first edge in the chain.

  2. Press Ctrl select the second edge, and do either of the following:
    • Position the pointer left of the midpoint to create a chain that moves left.
    • Position the pointer right of the midpoint to create a chain that moves right.
      Right of midpoint selected
  3. Right-click and choose Select Partial Loop.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Select Partial Loop
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.