Hide Table of Contents

Post-Processing

User interface enhancements:

  • Common access to Edit Definition, Chart Options, and Settings PropertyManagers.
  • Ability to edit the min and max values on plot legends. Click the min or max value of the plot legend and type a new value.
  • Quick access to the Fringe Options of the plot. Right-click anywhere on the plot legend boundary and click Fringe Options.
  • Ability to quickly change the display state of mesh on result plots. Right-click anywhere on the plot legend boundary and select or clear Show Mesh.

Contents

  • Mirrored Results About Planes of Symmetry

    For models where you apply planar symmetry or cyclic symmetry restraints to leverage the geometric and loading symmetry conditions, you can view results on the full model. The display of results on the full model, instead of only a section of the model, gives you better insight on the model behavior and helps you identify potential modeling errors.

  • Results Comparison Across Configurations

    With the Compare Results tool, you can compare up to four result plots from Simulation studies that are associated with different configurations of the same model.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Post-Processing
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59