Hide Table of Contents

Setting Up Models for Automation

Certain types of models are better suited to design automation than others. When setting up models for automation, consider how they fit into an assembly and how the parts might change when automated.

Example 1

This illustration shows a simple support that uses planes.

Several planes have been created so that the sketches and features can be referenced to them (coincident, up to surface, etc.) This allows the dimension for the plane to be changed and the extrusion extended with it. When placed in an assembly, other components can be mated to this plane so that they move with consideration to the parts altered.

Using a coincident mate with the face could cause problems with more complex parts.

Example 2

This fitting also uses planes. If DriveWorksXpress is suppressing or unsuppressing the flange feature, the face of the flange face used in the mate would no longer be there.

Planes have little effect on the part or assembly file size but do increase the stability of the part during part configuration. Stability becomes increasingly important as part complexity increases. This principle also applies to axes, although not ‘temporary axes’, which disappear if the geometry disappears.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting Up Models for Automation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.