Hide Table of Contents

Orient Annotation PropertyManager

You can change the view orientation of 3D annotations. When you change the view orientation, you can also change the annotation view to which the annotation belongs.

To change the view orientation of 3D annotations:

  1. Right-click a 3D annotation and select Change Annotation View > By Selection.
  2. In the graphics area, select a plane or planar face to define the new orientation.
  3. In the PropertyManager, select Change orientation view to move the annotation to the orientation view that corresponds with the new orientation.
  4. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Orient Annotation PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.