Hide Table of Contents

Creating Patterns as Assembly Features

For assembly holes and cuts, you can create linear, circular, table driven, and sketch driven patterns.

To create an assembly feature pattern:

  1. Create an assembly cut or hole.
  2. Do one of the following:
    • Click one of the following on the Features toolbar:
      • Linear Pattern
      • Circular Pattern
      • Table Driven Pattern
      • Sketch Driven Pattern
    • Click Insert > Assembly Feature, and select one of the following: Linear Pattern, Circular Pattern, Table Driven Pattern, Sketch Driven Pattern.
  3. Set options as needed in the PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Patterns as Assembly Features
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.