Hide Table of Contents

Bends

You can create bends and tangency at the junction of three cable segments.

AddBend-before.gif AddBend-after.gif
Before adding bends After adding bends

Adding Bends

To add bends, do one of the following:

  • Click Add Bends Tool_AddBends_RoutingTools.gif (Electrical toolbar) or Tools > Routing > Electrical > Add Bends and select the junction of three cable segments.
  • Right-click at the junction of three cable segments and select Add Bends.

Bends are added. The software determines the radii and entities to bend based on the wires passing through the point.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Bends
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26