Hide Table of Contents

System Options - Touch

Modify SOLIDWORKS interpretation of the two-finger pan and rotate gestures from the Touch node of the System Options dialog box.

To open the Touch area of the System Options dialog box:

With a document open on a touch-enabled computer, click Options Options (Standard toolbar), and click Touch.

Reset Restores factory defaults for all system options or only for options on this page.

Rotate and Pan

All options refer to the motion of two fingers moving together in unison. Depending on the initial distance between the two fingers, this gesture is interpreted as panning or rotation. Modify the distances in these options to differentiate the pan and rotate gestures.

Rotate width slider
  • Off interprets the two-finger gesture starting any distance apart as Pan.
  • As you drag the slider to the right, increases the maximum initial distance interpreted as Rotate.
Rotate versus pan threshold slider
  • Off interprets any initial two-finger distance wider than the Rotate width as Pan.
  • When your setting is added to the Rotate width, this sum interprets the two-finger distance as Rotate or Pan:
    • When the distance is less than the sum and greater than the Rotate width, SOLIDWORKS does not respond to the gesture.
    • When the distance is greater than the sum, Pan is interpreted.
    • When the distance is less than the Rotate width, Rotate is interpreted.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   System Options - Touch
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.