Hide Table of Contents

2D to 3D Toolbar

Front The selected sketch entities become the front view in converting to a 3D part.
Top The selected sketch entities become the top view in converting to a 3D part.
Right The selected sketch entities become the right view in converting to a 3D part.
Left The selected sketch entities become the left view in converting to a 3D part.
Bottom The selected sketch entities become the bottom view in converting to a 3D part.
Back The selected sketch entities become the back view in converting to a 3D part.
Auxiliary The selected sketch entities become an auxiliary view in converting to a 3D part. You must select a line in another view to specify the angle of the auxiliary view.
Create Sketch from Selections The selected sketch entities become a new sketch. You can extract a sketch, for example, and then modify it before creating a feature.
Repair Sketch You can fix errors in a sketch so that the sketch can be used to extrude or cut a feature. Typical errors can be overlapping geometry, small gaps, or many small segments that are collected into a single entity.
Align Sketch Select an edge in one view to align to the edge selected in a second view. The order of selection is important.
Extrude Extrude a feature from the selected sketch entities. You do not have to select a complete sketch.
Cut Cut a feature from the selected sketch entities. You do not have to select a complete sketch.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   2D to 3D Toolbar
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59