Hide Table of Contents

Configure Dimension

Use Configure Dimension to access the Modify Configurations dialog box, where you can configure sketch and feature dimensions.

You must exit the sketch or feature before you can configure its dimensions.

To configure a dimension:

  1. Select a feature, sketch, or mate in the FeatureManager design tree to make its dimensions visible in the graphics area.
  2. In the graphics area, right-click a dimension and click Configure Dimension menu_ConfigureThis.gif.
  3. In the Modify Configurations dialog box, you can:
    • Create new configurations.
    • Edit the dimension values for each configuration.
    • Click ModifyConfig_DropDownArrow.gif at the top of the column to select other parameters of the sketch or feature to configure.
      ModifyConfig_select_parameters.gif


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configure Dimension
*Comment:  

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2015 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.