Hide Table of Contents

Modifying Features

After you find features, you can modify them.

  1. In the Results tree, select the features to modify.
  2. Under Modify, click Parameters.

    A new dialog box appears, specific to the feature type, in which you can enter new parameter values.

  3. In the Modify dialog box, set the parameters and click OK.
  4. In the Find/Modify Features Task Pane, click Modify Selected to modify only the features you selected, or Modify All to modify all the features in the Results tree. For example, if you select a fillet and enter a new parameter of 5mm, selecting Modify All changes the radius of all fillets in the Results tree to 5mm.

    The values of the parameters are replaced with new values.

    The SOLIDWORKS software regenerates all features in the part after modifying each feature. This increases the processing time of the modify operation.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Modifying Features
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26