Hide Table of Contents

Quick Tips

Quick Tips is a set of pop-up messages that appear while you create SOLIDWORKS documents. These messages give hints and options based on the current SOLIDWORKS mode.

Most of the messages have hyperlinks that flash the tools typically used for the next step, point out informational messages, etc.

Quick Tips are not available when the SOLIDWORKS Tutorials are active.

Icons associated with Quick Tips appear at the right of the status bar:

Icon Status
Available, but not currently displayed
Currently displayed
Temporarily disabled

To turn Quick Tips on or off:

  • Click Help > Quick Tips or click .

    Quick Tips are mode-specific. For example, if you have Quick Tips displayed when you have a part document open, then you click , Quick Tips are no longer displayed in part modes. However, if you open an assembly document, Quick Tips reappear.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Quick Tips
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.