Hide Table of Contents

Determine Cut Lengths for Twisted Pairs

You can identify two or more wires to braid into a twisted pair and calculate its cut length.

To define twisted pairs, click Edit Wires or Tools > Routing > Electrical > Edit Wires.

In the Edit Wires PropertyManager, select the wires that will form a pair and in Wire From-To List, click Twisted Pair .

The wires must be of the same type and diameter.

The Twisted Pair Parameters dialog box displays and lists the selected wires. In the Twists per unit length field, set the number of turns per unit length that the wires require and click OK. SOLIDWORKS then calculates and displays the route and cut lengths of the braided wire based on the route segment.

For BOMs, an existing column for length has been renamed to Routed Length and a new column for Manufactured Length has been added. This column lists the required cut length for the twisted wires.

This functionality is limited to annotations and not available in 3D route geometry.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Determine Cut Lengths for Twisted Pairs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.