Hide Table of Contents

Slope PropertyManager

To open the PropertyManager, select a pipe segment in the graphics area and right-click Edit Route tool_edit_route.gif (Piping toolbar). Right-click the sketch entity at the location where you want to add the slope and select Add Slope add_slope_button .

  Route Segments Displays the segments of the pipe to be sloped. These segments must be axially aligned.
  Gravity Plane Displays a plane that defines the direction of gravity. Pipe segments that are not parallel to the plane are adjusted in length to accommodate the slope. Select Reverse direction PM_reverse_direction.gif if required.
start_point_for_slope Start Point Displays the start point for the slope. The start point must be a fixed point that the pipe segment can use to rotate and create the slope.
slope_angle Slope Angle Defines the ratio of the rise divided by the run between the start and end points of the pipe segment. The default ratio of the slope is 1units:1units.
  Weld Gap Adds weld gaps to the selected route segment.

Overrride default gap

Defines a value for the override default gap.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Slope PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48