Hide Table of Contents

Routing File Locations and Settings Dialog Box

Use the Routing File Locations and Settings tab to set file locations and options for Routing entities.

General Routing

Routing library Specifies the folder where you store Routing components.
Do not store Routing components in the SOLIDWORKS Toolbox library.

The Routing library folder is added to the Design Library, where you can access the components and drag them into a route.

In addtion, the Routing library folder is updated in Options > File Locations under Referenced Documents.

You must also select Search file locations for external references in Options > External References.

You can create additional folders under the Routing library folder to organize components.

Some sample Routing parts are supplied in the default Routing library folder.
Routing template Specifies the routing template to use for new route assemblies. Before specifying a template here, make sure its folder is listed as a Document Templates folder in Options > File Locations.

Piping/Tubing

Standard tubes Specifies the Excel file for standard tubes.
Covering library Specifies the .xml file for covering materials for pipes and tubes.
Tag scheme library Specifies the .xml file for tag schemes you define in the Tag Scheme Manager. You can also use this location to load existing tag scheme .xml files so the schemes display under Scheme view in the Tag Scheme Manager.
Tag schemes are only used in Routing assemblies created from P&ID data.

Electrical cabling

Cable wire library Specifies the .xml file for the cable/wire library.
Component library Specifies the .xml file for the component library.
Standard cable Specifies the Excel file for standard cables.
Covering library Specifies the .xml file for covering materials for wires and cables.

Options

Routing Library Manager Units Sets the default units for data on any tab in the Routing Library Manager.

Settings file

You can share file location settings with other users.

Load Settings Loads file location settings from a .sqy file.
Load Default

Resets file location settings to the original system defaults, which are in subfolders of C:\Documents and Settings\All Users\Application Data\SOLIDWORKS\SOLIDWORKS version.

Routing library \design library\routing
Routing template \templates\routeAssembly.asmdot
Standard tubes \design library\routing\Standard Tubes.xls
Covering library (Piping/Tubing) \design library\routing\coverings.xml
Tag scheme library \design library\routing\tag schemes.xml
Cable wire library \design library\routing\electrical\cable.xml
Component library \design library\routing\electrical\components.xml
Standard cable \design library\routing\Standard Cables.xls
Covering library (Electrical cabling) \design library\routing\electrical\coverings-electrical.xml
Save Settings Saves settings to an .sqy file location.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Routing File Locations and Settings Dialog Box
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.