Hide Table of Contents

Align Grid/Origin PropertyManager

By default, the origin of a block is aligned to the orientation of the sketch entity. Use Align Grid/Origin to re-orient the coordinate system of a sketch or block if they are not in the desired orientation.

Example block of origin orientation:
align_grid-origin01.gif align_grid-origin02.gif align_grid-origin03.gif
Sketch origin Block origins

You can change the origin location and orientation for blocks and sketches that are sketched on the face of a model or on planes.

To display this PropertyManager:

In a sketch, click Tools > Sketch Tools > Align > Align Grid/Origin.

Selections

PM_sketch_origin_location.gif Sketch Origin Location Select a vertex or a point.
  X-axis or Y-axis Select a linear sketch entity.
PM_flip_radiate_direction.gif   Click to flip the origin's orientation 180°.
  Relocate origin Only moves the origin's location.
  Relocate all sketch entities Move the sketch's location based on relocating:
  • Only the sketch origin
  • Only the X-axis or the Y-axis
  • Both the sketch origin and either the X-axis or the Y-axis
Example of Relocate all sketch entities:
sketch_origin_relocate_sketch01.gif sketch_origin_relocate_sketch02.gif
Original sketch origin Relocated sketch origin
sketch_origin_relocate_sketch03.gif sketch_origin_relocate_sketch04.gif
Selected X-axis Relocated sketch entities (new origin and axis)


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Align Grid/Origin PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.