Hide Table of Contents

Jogging Sketch Lines

You can jog sketch lines in 2D or 3D sketches in part, assembly, and drawing documents. Jog lines are automatically constrained to be parallel or perpendicular to the original sketch line.

You can drag and dimension jog lines.

sketch_jog_2D_ex.gif sketch_jog_3D_ex.gif

A jog with dimensions in a 2D sketch line.

Jogs in 3D sketch lines in different planes.

To jog a sketch line:

  1. In an open sketch with a line, or in a drawing with a sketched line, click Jog Line Tool_Jog_Line_Explode_Sketch.gif on the Explode Sketch toolbar, or click Tools > Sketch Tools > Jog Line.
  2. Click a line to begin the jog.
  3. Move the pointer to preview the width and depth of the jog.

    In 3D sketches, press Tab to change the plane of the jog.

  4. Click again to complete the jog.

    The Jog Line tool stays active so you can insert multiple jogs.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Jogging Sketch Lines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.