Hide Table of Contents

3D Sketching Capabilities

Constraints in 3D Sketching

When sketching in 3D, you can snap to the major directions, X, Y, or Z, and constraints are applied Along X, Along Y, and Along Z, respectively. These are constraints to the global coordinate system.

When sketching on a plane, you can snap to the horizontal or vertical directions in the plane, and constraints are applied to the Horizontal and the Vertical. These are constraints to a plane, planar face, etc.

Planes

You can add planes while in a 3D sketch. 3D plane attributes include:

  • Define. Planes can be fully defined, over defined and under defined.
  • Relations. You can:
    • Add or remove relations to planes.
    • Use relations to position other geometry or to position the plane.
  • Move. Move planes by dragging, resize planes by dragging the corner handles, and rotate planes using the center handles.
  • Activate. Double-click to activate a plane.

When you use RapidSketch with any open sketch tool, a plane is created on any planar face that you select.

Display

In the Properties PropertyManager, you can hide dimensions, relations or planes.

When sketching in the 2D mode on a 3D plane, entities that are not on the active sketch plane are muted.

Relations and dimensions that do not involve the plane or segment on it are hidden.

Sketcher Triad

Use the Sketcher Triad Sketcher_triad_3D.gif to limit the drag of entities.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   3D Sketching Capabilities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.