Hide Table of Contents

Configurable Items for Assemblies

You can vary the design of assembly configurations as follows:
  • Change the suppression state (Suppressed, Resolved) of components.
  • Change the referenced configuration of components.
  • Change the Display State.
  • Change the dimensions of distance or angle mates, or suppression state of mates.
  • Modify the dimensions, tolerances, or other parameters of features that belong to the assembly. This includes assembly feature cuts and holes, component patterns, reference geometry, and sketches that belong to the assembly (not to one of the assembly components).
  • Assign mass and center of mass.
  • Suppress features that belong to the assembly.
  • Define configuration-specific properties, such as end conditions and sketch relations.
  • Create derived configurations.
  • Change the size of Hole Wizard holes.
  • Fix or float the position of a component.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configurable Items for Assemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.