Hide Table of Contents

Example of Rib Feature with Reference Contour Draft

Click Next Reference until you select the contour to use as the reference contour.

You can select only one reference contour on which to base the reference draft.

Set a value for Draft Angle and create the rib.

Imagine the reference contour extends in a straight line through the model. Outward draft is applied in the direction of the Next Reference arrow (to the left of the reference contour line). Draft is applied perpendicular to the face created by the thickened reference contour.

The opposite type of draft, in this case inward draft, is applied to the model on the right side of the reference contour line.

The reference contour plane keeps the Rib Thickness value, while the thickness varies for the planes on which the other contours are located.

Select At sketch plane to apply the thickness to the rib at the sketch plane, or At wall interface to apply the rib thickness where the rib meets the wall.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example of Rib Feature with Reference Contour Draft
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.