Hide Table of Contents

Mold Tools - Parting Lines

Parting lines lie along the edge of the molded part, between the core and the cavity surfaces. They are used to create the parting surfaces, and to separate the surfaces. You create the parting lines after the model is scaled and proper draft is applied.

You can create:
  • Multiple parting line features in a single part.
  • Partial parting line features.
You can automatically split straddle faces found during draft analysis, either along the +/- boundary or at a specified draft angle. Additionally, you can split a face by selecting a sketch segment, a pair of vertices, or a spline on a surface. Before creating parting lines, you can use Parting Line Analysis Tool_PartingLineAnalysis_View.gif to visualize and optimize possible parting lines.
To make parting line features visible even when they are not selected, click View Parting Lines Tool_ViewPartingLines_View.png (View toolbar) or View > Parting Lines .

When you create the first parting line in a part, the software automatically creates the Cavity Surface Bodies folder fm_surface_bodies.gif and Core Surface Bodies folder fm_surface_bodies.gif and populates them with the appropriate surfaces. See Mold Folders.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Mold Tools - Parting Lines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.