Hide Table of Contents

Spherical and Curvilinear Mates

You can create mates using spherical bodies and surfaces.

You can create mates for spherical bodies with the following relationships:
  • Tangential to nonlinear edges and sketches
  • Tangent to nonplanar surfaces
You can create mates between elliptical, conical, and parabolic edges, sketch entities, and other geometry that are related as follows:
  • Coincident to a point
  • Tangent to a line, circle, cylinder, sphere, or ellipse

sphericalmodelbeforemating.png



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Spherical and Curvilinear Mates
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.