Hide Table of Contents

Automatically Splitting Tables Horizontally at a Row

You can use the Horizontal Auto Split command to make the SOLIDWORKS software automatically adjust table rows when you add or remove items from tables.

Supported tables:

  • Hole Tables
  • Bill of Materials
  • General Tables

The automatic splitting of tables applies to the entire table, including portions that appear on other drawing sheets.

You can specify that the new table segments be placed directly below the last table split or directly to the right of the last table split:

Before split:
Drawing_horizontal_auto_split1

After split, placed below:
Drawing_horizontal_auto_split2

After split, placed to the right:
Drawing_horizontal_auto_split3

To set up automatic splitting of a table:

  1. Right-click the table and click Split > Horizontal Auto Split.
  2. In the dialog box, enter a number in the Maximum number of rows field.
  3. Under Apply, select one of the following:
    • To apply the Maximum number of rows value to the table once, click This time only.
    • To continuously maintain the automatic splitting of the table, click Continuously

      As items are added and removed from the table, it is updated to remain in compliance with the Maximum number of rows value.

  4. Under Placement of new split tables, select one of the following:
    • To place the split portions of the table to the right, click Horizontal alignment.
    • To place the split portions of the table below, click Vertical alignment.
  5. Click Apply.
When Continuously is in effect for a table, to stop automatic splitting, right-click the table and click Stop Auto Splitting.

Current splits are kept but are no longer adjusted automatically as you make changes to the table.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Automatically Splitting Tables Horizontally at a Row
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.