Hide Table of Contents

Creating a New Display State

To create a new display state:

  1. Click a blank area in the graphics area to make sure nothing is selected in the ConfigurationManager.
  2. Right-click in any blank area in the ConfigurationManager and select Add Display State.

    A new display state is added to the list and becomes the active display state.

    The active display state appears in angle brackets after the configuration name in the ConfigurationManager and at the top of the FeatureManager design tree.

  3. In the FeatureManager, click fm_display_pane_expand.png (to the right of the tabs) to show the Display Pane, and make changes to define the new display state.

    You can also create a new display state by right-clicking anywhere in the Display Pane, selecting Add Display State, typing a name for the new display state, and pressing Enter.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a New Display State
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23